Three Phase Full Wave SCR - R Load

COMPONENTS

AC Source

Thyristor

Gate Pulse

Resistor

Ammeter

Voltmeter

Ground

OBSERVATION TABLE

S.No.	VL_rms (V)	IL_rms (A)	VL_avg (V)	IL_avg (A)

3

5

4

THY1

7

9

8

THY3

11

13

12

THY5

15

16

ILOAD

1

2

AC1

6

GP1

10

GP3

14

GP5

17

18

AC2

40

41

R

19

20

AC3

42

43

VLOAD

21

22

VR

31

GP4

35

GP6

39

GP2

23

24

VY

28

30

29

THY4

32

34

33

THY6

36

38

37

THY2

25

26

VB

27

GND

STEP 1: Drag and drop the components in the workspace to create the circuit.

Nos of required components:

AC Source – 3, Thyristor – 6, Gate Pulse - 6, Resistor - 1

Voltmeter – 4, Ammeter - 1, Ground – 1

STEP 2: Make the connections as per the instructions given below:

(a) (01-17, 02-21, 22-27, 02-04, 04-28, 05-06)

(b) (03-07, 09-10, 08-32, 07-11, 13-14, 12-36)

(c) (11-15, 18-23, 24-27, 18-08, 17-19, 19-27)

(d) (20-25, 26-27, 20-12, 30-31, 29-33, 34-35)

(e) (33-37, 38-39, 37-41, 37-43, 40-16, 42-16)

Note: Click on the wire to delete the connection.

STEP 3: Click on the CHECK button to check the connections.

Note: Right click on the component to open the dialog box to edit the properties of the component.

STEP 4: Input the values for all the required components(AC Sources, Gate Pulses and Resistor) and the waveform will get plot automatically.

STEP 5: Now, Click on the ADD button to insert the reading into the observation table.

STEP 6: Now, you can input different values as per your requirement to get the desired waveform.

STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.

STEP 8: Click on the PRINT button to take out the print of the webpage.

STEP 9: Click on the RESET button to reload the webpage.